Dehumidifiers – Floor Standing DH 600BY
The DH 600 high capacity floor standing dehumidifier is self-contained with fully automatic operation. With integral humdistat, and options for heating, condensate pump and external condenser unit, and high pressure fan, you can be sure in your space being controlled to your demands. This makes it ideal for warehousing and storage, sub stations, data centres and even pool halls.
Features
- Self contained with fully automatic operation
- Integral humidistat
- Polyester coated evaporator and condenser
- Plastisol coated galvanised steel cabinet
- Reverse cycle defrost for very low temperature operation
Options
- Top or rear fan outlet
- High pressure fan
- Return air filter
- Condensate pump
- Compressor soft start
- Top discharge box
- Heat recovery to water
- External condenser unit
- Remote humidistat
Applications
Archives
The life expectancy of archive collections is significantly affected by the environmental conditions in which they are stored. Environmental problems in buildings can cause significant damage to collections and preservation of historical documents is of vital national importance.
Providing the correct environmental conditions to preserve these items is vital and Zoe INTL’s range of powerful dehumidifiers offer the ideal means of preserving and protecting them from humidity damage. They are equally suitable for humidity control in warehouses, castles and historic buildings where excess humidity is a significant problem without a professional dehumidification solution.
How a dehumidifier works
The high-performance dehumidifiers recirculate the air and physically remove moisture from it. This alleviates the need to continuously reheat incoming air. Not only that, the units convert energy taken out of the room as moisture to provide useful heat to warm the room, accelerating the drying process.
Effective dehumidification provides maximum protection in museums and historic buildings where priceless exhibits and artefacts are stored. For example, if the relative humidity is too high, condensation can form on surfaces and mould and rot can set in, and the rising and falling of humidity levels can cause degradation. This can, however, be avoided by maintaining the relative humidity at both correct levels, and importantly at a stable level. Their functionality and easy operation make them ideal for large period properties, museums and archives and anywhere where preservation is vital.
Cost savings
Typically, as a by-product of the dehumidification process, for every unit of energy that our dehumidifier consumers, it will convert 2.5 times this amount to useable heat. The potential energy savings are huge. In fact, compared to using heating to try and control humidity levels, cost savings of 500% are not unusual. The units have built in humidity control, so will never waste energy when the correct humidity is reached, and there is no possibility of drying out the space too much.
Installation
Our dehumidifiers have a flexible design and are fully packaged, easy to install and can operate efficiently over an ambient air temperature range of between 0 and 40°C.
Zoe INTL manufacture dehumidifiers in a range of sizes to suit any space. Whatever you need, Zoe INTL, Calorex, Aerial and Master have the solution.
All products are supported by an in-house applications department and nationwide service network.
Commercial Car Storage
With over 20 years of experience developing dehumidifiers specifically for the classic car market, Zoe INTL is the number one go to company for any size car collection or storage facility. Our dehumidifiers will prevent corrosion of vulnerable metal surfaces and body panels and dry damp rooms substantially quicker than heat to the point where cars can be stored for indefinite periods of time without moisture related degradation. They will also dry a vehicle if it is returned to the garage whilst wet and provide a degree of background heating.
How a dehumidifier works
The high-performance dehumidifiers recirculate the air and physically remove moisture from it. This alleviates the need to continuously reheat incoming air. Not only that, the units convert energy taken out of the room as moisture to provide useful heat to warm the room, accelerating the drying process.
Cost savings
Our dehumidifiers provide an efficient and cost-effective alternative to drying using heat alone. The potential energy savings are huge as every unit of energy that one of our dehumidifiers consumes, it will convert 2.5 times this amount to usable heat. In fact, compared to traditional heat and ventilation energy, cost savings of 75% are not unusual.
Installation
Installations can be straightforward, as it only requires positioning, connecting a power supply and drain. The units have combined heating and drying so there is no need for separate heaters, thermostats, fans and extraction systems.
Zoe INTL manufactures dehumidifiers in a range of sizes from the smaller wall unit to the large floor standing industrial sized system. Whatever size garage or storage facility you have, Calorex, Zoe INTL, Aerial and Master will have the solution.
All products are supported by an in-house applications department and nationwide service network.
Data Centres
Where data centres are built in climatic regions that experience high air temperatures and moisture contents, humidity control must not be forgotten, so an environmental control system that incorporates humidity and temperature control must be considered. Humidity control is essential to stop moisture in the fresh air supply from condensing into the room, risking damage to valuable data centre infrastructure and operation.
Zoe INTL can provide reliable, energy-efficient solutions for all humidity problems, including data centres. To provide a solution that minimizes power consumption and capital cost, refrigerant dehumidifiers are often chosen as the preferred technology.
One of the largest data centre operators in Singapore has put its trust in specialist environmental control machines supplied by world leading Calorex, to help protect its valuable computer equipment from potentially catastrophic condensation. The company, which oversees a network of world-class data security bases in the Asia Pacific, ordered 48 DH 150 dehumidifiers for the suites within its new data centre.
Zoe INTL manufacture dehumidifiers in a range of sizes to suit any space. Whatever you need, Zoe INTL, Calorex, Aerial and Master have the solution.
Galleries
Zoe INTL dehumidifiers provide a reliable and efficient method of solving problems of excess moisture and condensation that cause damage and deterioration to ensure the safe storage of irreplaceable works of art.
Providing the correct environmental conditions to preserve these items is vital and our range of powerful dehumidifiers offer the ideal means of preserving and protecting them from humidity damage. They are equally suitable for humidity control in warehouses, castles and historic buildings where excess humidity is a significant problem without a professional dehumidification solution.
How a dehumidifier works
The high-performance dehumidifiers recirculate the air and physically remove moisture from it. This alleviates the need to continuously reheat incoming air. Not only that, the units convert energy taken out of the room as moisture to provide useful heat to warm the room, accelerating the drying process.
Effective dehumidification provides maximum protection in museums and historic buildings where priceless exhibits and artefacts are stored. For example, if the relative humidity is too high, condensation can form on surfaces and mould and rot can set in, and the rising and falling of humidity levels can cause degradation. This can, however, be avoided by maintaining the relative humidity at both correct levels, and importantly at a stable level. Their functionality and easy operation make them ideal for large period properties, museums and archives and anywhere where preservation is vital.
Steel
With uncontrolled storage comes the high risk of oxidisation and it is therefore essential to control and reduce humidity. Storage of such equipment as steel at the correct humidity is critical and can often reduce the requirement for additional surface protection systems whilst in storage.
Providing the correct environmental conditions to preserve these items is vital and Zoe INTL’s range of powerful dehumidifiers offer the ideal means of preserving and protecting them from humidity damage. They are equally suitable for humidity control in warehouses, castles and historic buildings where excess humidity is a significant problem without a professional dehumidification solution.
How a Zoe INTL dehumidifier works
The high-performance dehumidifiers recirculate the air and physically remove moisture from it. This alleviates the need to continuously reheat incoming air. Not only that, the units convert energy taken out of the room as moisture to provide useful heat to warm the room, accelerating the drying process.
Effective dehumidification provides maximum protection in museums and historic buildings where priceless exhibits and artefacts are stored. For example, if the relative humidity is too high, condensation can form on surfaces and mould and rot can set in, and the rising and falling of humidity levels can cause degradation. This can, however, be avoided by maintaining the relative humidity at both correct levels, and importantly at a stable level. Their functionality and easy operation make them ideal for large period properties, museums and archives and anywhere where preservation is vital.
Cost savings
Typically, as a by-product of the dehumidification process, for every unit of energy that a Zoe INTL dehumidifier consumer, it will convert 2.5 times this amount to useable heat. The potential energy savings are huge. In fact, compared to using heating to try and control humidity levels, cost savings of 500% are not unusual. The units have built in humidity control, so will never waste energy when the correct humidity is reached, and there is no possibility of drying out the space too much.
Installation
Zoe INTL dehumidifiers have a flexible design and are fully packaged, easy to install and can operate efficiently over an ambient air temperature range of between 0 and 40°C.
Zoe INTL manufacture dehumidifiers in a range of sizes to suit any space. Whatever you need, Zoe INTL, Aerial and Master have the solution. All products are supported by an in-house applications department and nationwide service network.
Storage
With uncontrolled storage comes the high risk of oxidisation and it is therefore essential to control and reduce humidity. Storage of such equipment as steel at the correct humidity is critical and can often reduce the requirement for additional surface protection systems whilst in storage.
Providing the correct environmental conditions to preserve these items is vital and Zoe INTL’s range of powerful dehumidifiers offer the ideal means of preserving and protecting them from humidity damage. They are equally suitable for humidity control in warehouses, castles and historic buildings where excess humidity is a significant problem without a professional dehumidification solution.
How a dehumidifier works
The high-performance dehumidifiers recirculate the air and physically remove moisture from it. This alleviates the need to continuously reheat incoming air. Not only that, the units convert energy taken out of the room as moisture to provide useful heat to warm the room, accelerating the drying process.
Effective dehumidification provides maximum protection in museums and historic buildings where priceless exhibits and artefacts are stored. For example, if the relative humidity is too high, condensation can form on surfaces and mould and rot can set in, and the rising and falling of humidity levels can cause degradation. This can, however, be avoided by maintaining the relative humidity at both correct levels, and importantly at a stable level. Their functionality and easy operation make them ideal for large period properties, museums and archives and anywhere where preservation is vital.
Cost savings
Typically, as a by-product of the dehumidification process, for every unit of energy that our dehumidifier consumers, it will convert 2.5 times this amount to useable heat. The potential energy savings are huge. In fact, compared to using heating to try and control humidity levels, cost savings of 500% are not unusual. The units have built in humidity control, so will never waste energy when the correct humidity is reached, and there is no possibility of drying out the space too much.
Installation
Our dehumidifiers have a flexible design and are fully packaged, easy to install and can operate efficiently over an ambient air temperature range of between 0 and 40°C.
Zoe INTL manufacture dehumidifiers in a range of sizes to suit any space. Whatever you need, Zoe INTL, Calorex, Aerial and Master have the solution.
All products are supported by an in-house applications department and nationwide service network.
Timber
With uncontrolled storage comes the high risk of oxidisation and it is therefore essential to control and reduce humidity. Storage of such equipment as steel at the correct humidity is critical and can often reduce the requirement for additional surface protection systems whilst in storage.
Providing the correct environmental conditions to preserve these items is vital and Zoe INTL’s range of powerful dehumidifiers offer the ideal means of preserving and protecting them from humidity damage. They are equally suitable for humidity control in warehouses, castles and historic buildings where excess humidity is a significant problem without a professional dehumidification solution.
How a Zoe INTL dehumidifier works
The high-performance dehumidifiers recirculate the air and physically remove moisture from it. This alleviates the need to continuously reheat incoming air. Not only that, the units convert energy taken out of the room as moisture to provide useful heat to warm the room, accelerating the drying process.
Effective dehumidification provides maximum protection in museums and historic buildings where priceless exhibits and artefacts are stored. For example, if the relative humidity is too high, condensation can form on surfaces and mould and rot can set in, and the rising and falling of humidity levels can cause degradation. This can, however, be avoided by maintaining the relative humidity at both correct level, and importantly at a stable level. Their functionality and easy operation make them ideal for large period properties, museums and archives and anywhere where preservation is vital.
Cost savings
Typically, as a by-product of the dehumidification process, for every unit of energy that a Zoe INTL dehumidifier consumers, it will convert 2.5 times this amount to useable heat. The potential energy savings are huge. In fact, compared to using heating to try and control humidity levels, cost savings of 500% are not unusual. The units have built in humidity control, so will never waste energy when the correct humidity is reached, and there is no possibility of drying out the space too much.
Installation
Calorex dehumidifiers have a flexible design and are fully packaged, easy to install and can operate efficiently over an ambient air temperature range of between 0 and 40°C.
Zoe INTL manufacture dehumidifiers in a range of sizes to suit any space. Whatever you need, Zoe INTL, Calorex, Aerial and Master have the solution.
All products are supported by an in-house applications department and nationwide service network.
Underground Storage
Typical underground facilities are constructed into or under the earth in order to use them as storage spaces for goods and especially documents, archives and artwork. In order to use underground facilities efficiently, it is very important to maintain the atmosphere conditions of the space appropriately to its usage.
Providing the correct environmental conditions to preserve these items is vital and Zoe INTL’s range of powerful dehumidifiers offer the ideal means of preserving and protecting them from humidity damage. They are equally suitable for humidity control in warehouses, castles and historic buildings where excess humidity is a significant problem without a professional dehumidification solution.
How a dehumidifier works
The high-performance dehumidifiers recirculate the air and physically remove moisture from it. This alleviates the need to continuously reheat incoming air. Not only that, the units convert energy taken out of the room as moisture to provide useful heat to warm the room, accelerating the drying process.
Effective dehumidification provides maximum protection in museums and historic buildings where priceless exhibits and artefacts are stored. For example, if the relative humidity is too high, condensation can form on surfaces and mould and rot can set in, and the rising and falling of humidity levels can cause degradation. This can, however, be avoided by maintaining the relative humidity at both correct level, and importantly at a stable level. Their functionality and easy operation make them ideal for large period properties, museums and archives and anywhere where preservation is vital.
Cost savings
Typically, as a by-product of the dehumidification process, for every unit of energy that our dehumidifier consumers, it will convert 2.5 times this amount to useable heat. The potential energy savings are huge. In fact, compared to using heating to try and control humidity levels, cost savings of 500% are not unusual. The units have built in humidity control, so will never waste energy when the correct humidity is reached, and there is no possibility of drying out the space too much.
Installation
Our dehumidifiers have a flexible design and are fully packaged, easy to install and can operate efficiently over an ambient air temperature range of between 0 and 40°C.
Zoe INTL manufacture dehumidifiers in a range of sizes to suit any space. Whatever you need, Zoe INTL, Calorex, Aerial and Master have the solution.
All products are supported by an in-house applications department and nationwide service network.